Grasshopper

algorithmic modeling for Rhino

00 | Honeybee
01 | Daylight | Material
02 | Daylight | Light Source
03 | Daylight | Recipes
04 | Daylight | Daylight
05 | Energy | Building Program
06 | Energy | Material | Construction
07 | Energy | Schedule
08 | Energy | Set Zone Properties
09 | Energy | HVACSystems
10 | Energy | Energy
11 | THERM
12 | Developers
13 | WIP

Read EP HVAC Result

Component Index > Honeybee > 10 | Energy | Energy > Read EP HVAC Result

This component reads the results of an EnergyPlus simulation from the WriteIDF Component or any EnergyPlus result .csv file address. Note that, if you use this component without the WriteIDF component, you should make sure that a corresponding .eio file is next to your .csv file at the input address that you specify.
This component reads only the results related to zone ideal air and earth tube HVAC systems. For other results related to zones, you should use the "Honeybee_Read EP Result" component and, for results related to surfaces, you should use the "Honeybee_Read EP Surface Result" component.

Inputs

NameIDDescriptionType
_resultFileAddress_resultFileAddressThe result file address that comes out of the WriteIDF component.Goo

Outputs

NameIDDescriptionType
supplyVolFlowsupplyVolFlowThe mass of supply air flowing into each zone in kg/s.Goo
supplyAirTempsupplyAirTempThe mean air temperature of the supply air for each zone (degrees Celcius).Goo
supplyAirHumiditysupplyAirHumidityThe relative humidity of the supply air for each zone (%).Goo
unmetHoursCoolingunmetHoursCoolingTime Zone Cooling Setpoint Not Met TimeGoo
unmetHoursHeatingunmetHoursHeatingTime Zone Heating Setpoint Not Met TimeGoo

© 2018   Created by Robin Rodricks and Andrew Heumann.   Hosted by

Badges  |  Report an Issue  |  Terms of Service