algorithmic modeling for Rhino

00 | Honeybee
01 | Daylight | Material
02 | Daylight | Light Source
03 | Daylight | Recipes
04 | Daylight | Daylight
05 | Energy | Building Program
06 | Energy | Material | Construction
07 | Energy | Schedule
08 | Energy | Set Zone Properties
09 | Energy | HVACSystems
10 | Energy | Energy
11 | THERM
12 | Developers
13 | WIP


Component Index > Honeybee > 10 | Energy | Energy > ShadowPar

EnergyPlus Shadow Parameters


calculationMethod_calculationMethod_An optional text string to set the means by which the shadow calculation is run. Choose from the following two options: 1 - AverageOverDaysInFrequency - A shadow calculation that averages over multiple days (as opposed to running it for each timeStep). This is the default setting. 2 - TimestepFrequency - A shadow calculation that computes the incoming solar energy at every single timestep of the simulation. Note that this option is only needed for certain cases and can increase execution time significantly.Goo
frequency_frequency_An optional number that represents the frequency in days with which shadows are re-computed in the AverageOverDaysInFrequency calculation method. The default is set to 30 days (meaning that the shadow calulation is performed every 30 days and this average over this period is used to represent all 30 days in the energy simulation).Goo
maximumFigure_maximumFigure_An optional number that is greater than 200, which represents the maximum number of points to be used in the shadow calculation. The default is set to 3000 points but this may need to be increased significantly if you have a lot of small context geometry in your model.Goo


shadowParshadowParShadow calculation parameters that can be plugged into the "Honeybee_Energy Simulation Par" component.Goo

© 2018   Created by Robin Rodricks and Andrew Heumann.   Hosted by

Badges  |  Report an Issue  |  Terms of Service