algorithmic modeling for Rhino


Print 3D - Filament

Component Index > Xylinus > Filament > Print 3D - Filament

Slices input geometry and renerates G Code to print [W] walls and infill at [I] density. Works for simple or complex geometries.

a W# walled form without any infil or top/bottom layers. For standard filament printing.


GeometryGContains a collection of generic geometryGeometricGoo
Primary config for 3DP_FCPrimary configuration for 3D printing with filamentGoo
Perimenter Wall CountWnumber of solid perimeter walls to printInteger
Infill Ratio (0-1)ISet the density of the infill from 0 (none) to 1 solid).Number
start and end g codeSEBoolean input to determine wether or not to add the start and end g code needed to intiate and end a print. You may also adda customized start and end gcode sequences from the Start G Code and the End G Code components.Goo


G CodeGCComplete g code for printing a single wall model with no infillGoo
PointPtContains a collection of three-dimensional pointsPoint
Printer LinesPlpolylines representing the travel paths to be printedCurve
Total Filament Extruded (mm)FResult of mass additionGoo

© 2018   Created by Robin Rodricks and Andrew Heumann.   Hosted by

Badges  |  Report an Issue  |  Terms of Service