Grasshopper

algorithmic modeling for Rhino

Core
Filament
Syringe
DLP

Print Curve - Filament

Component Index > Xylinus > Filament > Print Curve - Filament

Converts a curve into g code to 3D print with a standard filament based printer

Inputs

NameIDDescriptionType
Curve GeometryCrvinput curve to traceCurve
Primary config for 3DP_FCOptional configuration for 3D printing with filament. Direct entries will override these config entries.Goo
start and end g codeSEBoolean input to determine wether or not to add the start and end g code needed to intiate and end a print. You may also adda customized start and end gcode sequences from the Start G Code and the End G Code components.Goo

Outputs

NameIDDescriptionType
G CodeGCComplete g code for printing a single wall model with no infillGoo
PointPtContains a collection of three-dimensional pointsPoint
Printer Lines as polylinesPlpolyline describing the path traveled by the printer.Curve
Total Filament Extruded (mm)Festimate of the total amount of filament needed to complete this section of g codeGoo

© 2018   Created by Robin Rodricks and Andrew Heumann.   Hosted by

Badges  |  Report an Issue  |  Terms of Service